Equipment designed for Industrial Applications...
UniMag measures Paper Pulp
A 200mm UniMag (DT) flowmeter was chosen to meter thick paper stock at UK Paper. Standard pulsed DC meters are not suitable for this application as there is too much noise from the solid matter in the paper stock. Pulsed AC meters have an energizing current of approx. 5amps and operate at a frequency of 40Hz giving them a huge improvement in signal to noise ratio. The MicroDelta pulse converter is seen in the foreground. The DeltaMag meter replaced a conventional pulsed DC meter.

Product:
UniMag DT


UniMag measures Concrete
A 5" UniMag (DT) flowmeter was installed on a piledriver pouring raw concrete into the ground. The concrete had stones, concrete slurry, and water and was thought to be impossible to meter. A meter is desirable as the flow and shape of the concrete pile can be controlled. A conventional meter had completely failed in the same location on a previous trial. This meter has now been working for over 2 years without fail.

Product:
UniMag DT


Delta Mass measures Dredging Mud
The image below shows a 32" DeltaMass Mass Flow Meter giving the output in tonnes/hour of dredging mud being dragged up from the New Orleans Estuary.
The meter gives an accurate volumetric signal despite the stones, gravel and silt slurry and combines this with and a density signal given by an integral nucleonic density gauge. The skipper of the dredger can set the speed of the pump so he neither burns out the motors by dredging too hard, or too little if the silt contains too much water. A special dredging efficiency logger is also available to plot the optimum cross over point. DeltaMass provides a % solids signal to the logger which is displayed.

Product:
DeltaMass MT