Berlingo
/ Partner
FITTING-GUIDE PAGE - 2
REAR
DOOR
|
|
 |
 Click
on any picture to enlarge!
STEP 4
|
|
Start
by removing any protective ply-lining which may have
been fitted. Once this has been removed, remove the
trim-plugs using the tack-remover.
|
| Now
remove the lock-circlip as shown in the photograph.
Please note that you will not be refitting this when you
later reassemble the door.
|
|
| STEP 5 |
|
|
Using the supplied gasket as a
template, mark the door for drilling. Note the orientation of the gasket in the
photo!
Drill a pilot hole first, as
shown.
|
|
STEP 6
|
| On
the back of the door-skin is a secondary skin which
needs to be removed. This skin is only held on with an
adhesive coated foam strip and after the drilling has
taken place, it will be easy to remove. Click on the
image below to see how it is removed....
You
will see in the photo that there are 3 steps involved. The
third and final step shown above, is to bend the two
"tabs" back so that they allow the backplate to
sit flush against the door skin..
Go
To Next Page
|
|
