| Using
the gasket as a template, mark the drill-holes as shown
in the photograph.

Since
this area of the door is double-skinned, you will need
to drill a pilot-hole before using your large drill bit.

With the
holes drilled and the painted with touch-up paint, you
can now fit the zinc-coated backing plate and reinsert
the lock barrel.
STEP 7

Now you
are ready to fit the stainless-steel frontplate. Fit the
two gaskets to the back of the plate and apply a small
amount of silicone around the threaded stud areas. Then
fit the plate to the door as indicated in the picture
above and after fitting the small spacer strip show
below, attach the Nyloc Lock Nuts and tighten.

DO NOT OVER-TIGHTEN
THE NUTS!
STEP 8

Now
check the alignment of the plate in relation to the keyhole
and use a soft-faced mallet to gently tap the edge of the
plate if required. Since you did not overtighten the
locknuts, there will be a small amount of movement
available.
Congratulations!
You have just fitted the best lock protection system on the
market.
Fit
Rear Door
Fit
Side Door
|