Fit
the gasket to the back of the stainless steel frontplate
and apply a small amount of silicone around the stud
areas.
Fit the
plate to the door.
Now you need
to fit the 2nd backing plate, attach the Nyloc
Locking Nuts and tighten.
Do not
over-tighten!!
You will
notice that access to two of the nuts is very awkward,
so you need to drill two access-holes as shown. Click
the photo on the left to see how.
STEP 5
Finally,
you need to check for correct alignment using your
door-key and if required, align the plate correctly by
gently tapping the edge of the plate using a soft-faced
mallet.
Congratulations!!
You just fitted the best lock-protection system
available on the market!
Click
on any picture to enlarge!
