ARMAPLATE FITTING INSTRUCTIONS

ARMAPLATE LOCK PROTECTION SYSTEM
Installation Guide

TRANSIT 2000 FITTING-GUIDE Pg.3

FRONT DOORS

Click any picture to enlarge it! STEP 7
	With the door-trim removed, you can now use a pair of pliers to remove the lock-barrel-circlip. Note, you will not be replacing this item.

STEP 8

It's now time to remove the lock-barrel. This is achieved in two steps.

(1) Turn the lock clockwise and then (2) press the release latch with a small screwdriver from the inside of the door. You can now withdraw the barrel.

STEP 9

To significantly enhance the security of your Ford door-locks, we provide an upgrade kit which should be fitted by following the instructions below.

Remove the plastic cap by prising with a small screwdriver to reveal the small keyhole-surround. This will be replaced with the unit provided in your kit.

There are 3 simple steps to performing this upgrade..

Refit the original spring-loaded flap.
Fit the new keyhole-surround and tap it gently into place with a hammer.
Test the spring-loaded flap with a small screwdriver.

That's all there is to it! Now you can proceed to the next stage of the Armaplate installation.

Click here to proceed to the next page

Want to go back to an earlier page?

Pg1 Pg2