Body Work
Rear edge of boot floor. DPO had plated over the holes
Another view of the outer valance/boot floor joint.
|
Body Work |
||
| Boot floor with the rear double exhaust hanger removed. |
Rear edge of boot floor. DPO had plated over the holes |
Same area but with the rear inner valance removed |
|
|
|
|
| Corresponding rot on rear inner valance. I'll weld a strip of new metal on this as replacement are expensive |
Another view of the outer valance/boot floor joint. |
Rear valance removed and rot cut out of boot floor |
|
|
|
|
| Old and new BMH valance for comparison. New Panel is about 10mm too short so will need a strip welding onto the lower edge. Width wise it is perfect. | Section of new floor ready for welding. It was cut from a scrap Stag. | After welding, just a small piece needed to complete the floor repair |
|
|
|
|
| Inner Valance with repair section welded in | Outer Valance fitted with self tappers awaiting welding | View from inside the boot. |
|
|
|
|
| Left view of boot after repair and painting | Other side with fuel pump and plumbing installed | External view after a coat of primer |
|
|
|
|
| Rear light panel primed | ||
|
|
||
